Telephone Base And Charger Installation; Charger Installation - AT&T CL82209 Quick Start Manual

Telephone base & charger installation
Install the telephone as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see user's manual for details.
1. Plug one end of
the telephone line
cord into the
telephone jack on
the bottom of the
telephone base.
7. Raise the antenna.
6. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
Charger
installation
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement power
adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
2. Route the power adapter cord through the slot.
Telephone line
cord
If you have DSL high
speed Internet
service, a DSL filter
(not included) is
required.
www.telephones.att.com
. In Canada, dial
1 (866) 288-4268
2
3. Plug the small
end of the
telephone base
power adapter
into the power
jack on the
bottom of the
telephone base.
4. Place the cords
into the
channels.
Power
adapter
5. Plug the large end of
the power adapter
into a power outlet
not controlled by a
wall switch.
Plug the power adapter
into an electrical outlet
not controlled by a wall
switch.
, or call
.