HUSTLER raptor Operator's Manual page 33

B
A. Filter
Figure 4-4
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
Modifying or Tampering with the evaporative emissions con-
trol system or the fuel system is prohibited. Federal law and
California State law prohibit the following acts or the causing
thereof:
1. The removal or rendering inoperative by any person
other than for purposes of maintenance, repair,
replacement, of any device or element of design incor-
porated into any equipment for the purposes of emis-
sions control prior to or after its sales or delivery to the
ultimate purchaser or while it is in use, or
605686
A
B. Filter guard
2. The use of the equipment after such device or element
of design has been removed or rendered inoperative by
any person.
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
The fuel tank is located under the seat platform with the
filler neck and fuel cap located in the left side fender.
Figure 4-5
Park the mower on level ground before filling fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
When threading the fuel cap onto the filler neck, tighten the
cap until it begins to click, then, continue to turn it until at
least three clicks are heard.
A. Fuel cap
IMPORTANT: Do not overfill the fuel tank. The fuel tank
should be filled no higher than the bottom of the fill neck.
4-3
A
Figure 4-5
REV E