Reception Errors - Toshiba GA-1200 Administration Manual

3 TROUBLESHOOTING

Reception errors

Error code
80
90
91
92
93
94
95
9A
38 Error code list
Cause
A sequence error occurred on the USB
interface.
The InternetFax or Email could not be
received properly for any of the following
reasons and thus it was forwarded to a des-
ignated address as an error:
The data are corrupted.
Any of the format, compression
method, resolution and paper size of
the data is not supported by this equip-
ment.
The InternetFax or Email could not be
received properly for any of the following
reasons:
The data are corrupted.
Any of the format, compression
method, resolution and paper size of
the data is not supported by this equip-
ment.
The InternetFax or Email could not be
received properly for any of the following
reasons and thus it was forwarded to a des-
ignated address as an error:
The data are corrupted.
Any of the format, attachment file for-
mat and character set of the data is not
supported by this equipment.
The InternetFax or Email could not be
received properly for any of the following
reasons:
The data are corrupted.
Any of the format, attachment file for-
mat and character set of the data is not
supported by this equipment.
The InternetFax or Email could not be
received properly due to the insufficient
memory space and thus it was forwarded to
a designated address as an error.
The InternetFax or Email could not be
received properly due to the insufficient
memory space.
In the offramp gateway function, the for-
warding of the InternetFax or Email was
stopped by the offramp security setting
because the Fax number of the destination
was not registered in the address book.
Countermeasure
Turn the power of this equipment OFF and
then back ON. If the error still occurs, con-
tact your service technician or service repre-
sentative.
Check the forwarded data. Or refer to the
Scanning Guide and check the data speci-
fications which this equipment can receive.
Then ask the sender to retry the transmis-
sion in an acceptable format.
Refer to the Scanning Guide and check the
data specifications which this equipment
can receive. Then ask the sender to retry
the transmission in an acceptable format.
Check the forwarded data. Or refer to the
Scanning Guide and check the data speci-
fications which this equipment can receive.
Then ask the sender to retry the transmis-
sion in an acceptable format.
Refer to the Scanning Guide and check the
data specifications which this equipment
can receive. Then ask the sender to retry
the transmission in an acceptable format.
Check the forwarded data. Or wait until a
job in process is completed, and then
ensure sufficient space in the memory. Then
ask the sender to retry the transmission.
Wait until a job in process is completed, and
then ensure sufficient space in the memory.
Then ask the sender to retry the transmis-
sion.
Check the Fax number in the RECEPTION
JOURNAL, and then notify the sender that
the forwarding was stopped.
If necessary, refer to the Setup Guide for
Scanning Functions or the Operator's
Manual for Facsimile Function and regis-
ter the Fax number into the address book.