The "Hybrid" Operating Mode; Operating Mode At Initial Start-Up; Using The "Hybrid" Operating Mode; Air Quality Indicator - Boneco H680 User Manual

48
THE "HYBRID" OPER ATING MODE
en

OPERATING MODE AT INITIAL START-UP

The BONECO H680 uses the "Hybrid" operating mode
when being switched on for the first time: This operating
mode cleans the air while humidifying it at the same time.
The humidity can be regulated at will (see page 51).
Air purification works automatically and without user
interaction.
The fan level is controlled by the electronics and adapts
to the environment to ensure the most efficient cleaning
and/or humidification possible.
Fan noise may be clearly audible at first; it will decrease
after a few minutes, however, once the humidity gets
closer to the desired value.

USING THE "HYBRID" OPERATING MODE

1. Switch the appliance on by tapping the
The particle sensor automatically begins measuring the
amount of dirt in the air. The appliance starts the hu-
midifying process automatically if humidity is below 50%.

AIR QUALITY INDICATOR

After being switched on, the BONECO H680 carries out
an initial air measurement and the
After measuring the air, the display shows the current air
quality (see figure below).
The cleaner the air is, the more segments are shown in
white.
button once.

BASIC SETTINGS

The BONECO H680 saves all of the settings if you switch
symbol flashes. off the appliance using the
The basic settings described here ("Hybrid" operating
mode, "AUTO" comfort mode, etc.) can be restored at
any time. Disconnect the appliance from the power grid
for about 10 seconds by unplugging the power cord from
the power outlet.
button.