Epson SureColor F6200 User Manual page 85

LCD screen message Solution
Command Error
Press the
installed RIP software is compatible with the product.
Check print settings on
RIP.
F/W Install Error Turn off the product, wait a few minutes, and turn it on again. Then reinstall
the firmware again.
Firmware update failed.
If this message persists, contact Epson for support.
Restart the printer.
Paper Cut Error Press the OK button, pull out the paper, and cut the media using scissors or
a third-party cutting tool.
Remove uncut paper.
Paper Size Error Press the OK button and remove the currently loaded media. Be sure the
media is at least 10 inches (254 mm) wide.
Loaded paper is not
supported size. If this message appears even when the media is the correct width, turn off
the Paper Size Check setting and try printing again.
Maintenance Request The product part indicated is nearing or at the end of its service life. Contact
Epson for support and provide them with the service code shown on the LCD
Replace Part
screen.
Soon/Replace Part Now
You must replace the part before printing again. If you continue to print, a call
XXXXXXXXXX
for service occurs.
Call For Service A call for service occurs when:
XXX Error XXX • The power cable is not connected securely
Power off and then on. If • An error occurs that cannot be cleared
this doesn't work, note
When a call for service has occurred, the printer automatically stops printing.
the code and call for
Turn off the printer, disconnect the power cable from both the outlet and the
service.
printer, and then reconnect them. Turn the printer on and off several times. If
the same call for service is displayed on the LCD screen, contact Epson for
support and provide them with the service code shown on the LCD screen.
Status Icons
pause/cancel button and select Job Cancel. Make sure the
85