Control Panel; Operating Instructions - Schumacher SE-1-12S Owner's Manual

11.

CONTROL PANEL

LED Indicators
POWER ON (green) LED: Indicates the charger is connected to an
AC power source and is receiving power.
CHARGED (red) LED: Indicates the battery is fully charged and the
charger is in maintain mode.
12.

OPERATING INSTRUCTIONS

accordance with the assembly instructions before it is used.
The charger does not have an ON/OFF switch. The On and Off
commands are controlled by plugging the charger into a 120V AC
electrical wall outlet only after the battery connections have been
made.
Charging
1. Ensure that all of the charger components are in place and in
good working condition.
2. Connect the battery following the precautions listed in sections 6
and 7.
3. Connect the AC power following the precautions listed in
section 8.
4. The POWER ON (green) LED will light when the AC cord is
properly connected. When the battery is charged the CHARGED
(red) LED will light.
5.
To disconnect, reverse the procedure.
NOTE: This charger is equipped with an auto-start feature. Current
will not be supplied to the ring terminals until a battery is properly
connected. Meaning, the clips will not spark if touched together.
Automatic Charging Mode
When an Automatic Charge is performed, the charger switches to the
Maintain Mode (see below) automatically after the battery is charged.
For a battery with a starting voltage under 1 volt, use a manual
charger to pre-charge the battery for five minutes to get additional
voltage into the battery.
This battery charger must be properly assembled in
• 11 •