1.8.1
Error codes and diagnostic codes
The drive electronics are capable of rectifying some errors automatically. In this case the status
display will cease to flash. Please switch the remote on and off several times. Wait approx. 5
seconds each time before switching the remote on again. If this does not rectify the error, locate
the error using the flash codes shown below.
FLASH
CODE
1
Module defective.
2
Lifter raised or
lowered too far (seat
not at driving height)
Accessory error.
3
Error on right motor.
Connection
loose/faulty.
4
Error on left motor.
Connection
loose/faulty or motor
faulty.
18
FAULT
IMMEDIATE MEASURE
-
•
If lifter is raised, lower in
stages until the status
display stops flashing. If
lowered too far, raise lifter
in stages until the status
display stops flashing. If at
all possible, only drive
when the seat is at driving
height.
-
•
Check plug-in connectors. •
•
Check plug-in connectors. •
FURTHER HELP
•
Consult dealer.
-
•
Consult dealer.
Consult dealer.
Consult dealer.