Vision techconnect control 3 Owner's Manual page 9

ADVANCED MODE PROGRAMMING
NOTE: Device must use mains-power for these advanced functions.
Use when you need to
 Program multiple codes to each button
 Use RS-232 or 12v trigger
 Add an extension keypad
 Program scheduled actions
 Duplicate to multiple devices
1. LOAD SOFTWARE ONTO PC Download from Vision's website:
www.visionaudiovisual.com/techconnect/tc2-ctl3
2. CONNECT CONTROL MODULE VIA USB In the battery compartment there is a standard
USB-B mini connector. (USB cable not included)
The software can be used without a control module connected, but if learning IR codes you
will need to connect a control module.
3. LAUNCH SOFTWARE You can create a new program, edit program saved on PC, or edit
program saved on device.
If an extension keypad is used all code will be saved on
the master device. The slave device is connected to the
master via the RS485 terminal.
To find firmware version of your device click "Read CTL3
Time"
9
TC2-CTL3_manual_en