Vision techconnect control 3 Owner's Manual page 8

SIMPLE MODE PROGRAMMING
Appropriate for controlling one IR device only, e.g. projector.
1. PUT DEVICE INTO LEARN MODE Press and hold buttons 3 and 4 (middle buttons). The
learn LED on the front panel will turn red and stay on.
2. PRESS BUTTON TO ASSIGN CODE TO Press function button on the front panel which the
incoming code will be assigned to. One code can be assigned to each button.
3. TEACH CODE Point remote control at the front panel of Control module. Press and hold the
button on the remote until the green confirmation LED flashes.
If red LED flashes it has failed to learn the code. Try again.
NOTE: Remote control should be 100mm from IR receiver and not held at an angle. Shield
from ambient light.
4. REPEAT The device will revert back to normal mode once it has learnt a code. Repeat steps
above to program other buttons.
BUTTON 2
Automatically sends code twice. Suitable for projector off. This can be disabled with the
computer software.
BUTTON 5/6
Sends codes repeatedly when held down. Suitable for volume control. This can be disabled
with the computer software.
8
TC2-CTL3_manual_en