Vision techconnect control 3 Owner's Manual page 12

d. If adding IR codes a learn button will be to the right of each code.
i. Connect a TC2-CTL3 to PC with a USB cable.
ii. Press learn then wait until the red LED lights on the module
iii. Point original remote at front of module and press and hold button
iv. Once you have finished the button will be blue to show codes are
allocated.
Note: External power is not required for the module. Set power switch to "PWR".
e. The save button will not un-grey until all fields are complete.
Must type a model name
before Save is available.
12
TC2-CTL3_manual_en