Vision techconnect control 3 Owner's Manual page 10

4. START BY ASSIGNING CODES click a button on the image. This window allows you to set
the codes for that button 1.
Repeat: when you hold the button down the codes are
repeatedly sent
Sequential: 1 st
command 2, etc.
Simultaneous: All commands are send at the same time
5. SELECT EXISTING CODES If codes are already in the library then select the device and
function in the drop-down menus. The code will appear.
NOTE: The software contains a pre-set library of RS-232 codes. When you add new codes
and sync and software, those new codes become available to all users when they sync
press sends command 1, 2
Select
RS-232 / IR / 12V
nd press sends
Note: it is not possible to set
a delay for 12v triggers
10
TC2-CTL3_manual_en