Connections And Copying - Daewoo SD-8100 Owner's Manual

DVD-Video(PAL) 02.3.15 5:44 PM ˘ ` 44

Connections and Copying

If you are using a SCART cable, select the AV input on the TV to see the picture from the player.
If you are not using a SCART cable, select the button number on the TV reserved for video input to see the picture
from the player.
To the TV via antenna cable (if you are not using a SCART cable)
If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just
tune the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to ensure the best
pictures and sound.
44
1
Once you have carried out the steps in "Connecting
up the player" , switch on your TV.
Press the OK button of the player's remote control
longer than 5 seconds to call the player´s test
picture.
Tune the TV to the test picture using the channel pre-
set functions of your TV as described in its manual.
When you have found the test picture, store it under
the button number on your TV for player input.
Press the OK button of the player's remote control
again longer than 5 seconds to release the test
picture.
2
• If the quality of the test picture transmitted to the TV is
poor due to interference caused by a station
transmitting on channel 52, you can tune the player to
a different transmitting channel. Find a free channel
between 21 and 69 on your TV.
Call the player's "MAIN SETUP" choose
"VCR SETUP" then "RF OUTPUT SET".
Type in the free channel.
Store and exit.
C H E C K
• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help
(refer to the TV manual).
• Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.
U P !
RF OUTPUT SET
CH 52
0-9:SELECT (21-69)
OK:CONFIRM SETUP:END