Answering System Feature Setup; Feature Summary - AT&T 9371 User Manual

9371_book_1ATT 8/14/01
ANSWERING SYSTEM OPERATION
AT THE BASE

Answering System Feature Setup

You can set up one feature at a time, or you can set up a feature and then
move on to set up another feature.
1
Make sure the answering system is on.
Press and release U until you hear the system announce the
2
feature you want to set. Refer to the "Feature Summary" below for a
description of the features and your choices.
Press S to hear the feature's settings.
3
Press t to confirm your selection.
4

Feature Summary

Default settings indicated by
System announces:
"Change remote access code" Set the remote access code you will use
19 *
"Change clock"
"Change message alert"
Off
*
On
"Change announce only"
Off
*
On
"Change call screening"
On *
Off
"Change number of rings"
2
4 *
6
Toll Saver
NOTE: Exit Feature Setup at any time by pressing an MBOX/STOP button.
22
10:00 AM Page 22
* .
Description/directions:
to access features and functions of the
answering system from a touch tone phone.
Set the clock: After you set the day, repeat
Steps 3 and 4 in "Answering System
Feature Setup" to set hours and minutes.
When Message Alert is turned on, the base
beeps once every 10 seconds when new
messages have been received.
When you turn Announce Only on, callers
hear your announcement,but cannot
leave a message.
Turn call screening on or off.
Choose how many times the phone will
ring before the system answers a call.
With Toll Saver active, the system answers
after two rings when you have new
messages and after four rings when you
have no new messages.