Special Considerations - Jenn-Air JS48PPDBDA Design Manual

I N S TA L L AT I O N G U I D E – S P E C I A L C O N S I D E R AT I O N S

Special Considerations

The illustrations on this page may be useful to help
you understand some of the situations you may face
as you design and install the various models of
Jenn-Air Built-In Refrigerators.
®
Figures 12-14 demonstrate handle placement for the
framed models. Figure 14 also shows the optional
handle extension as referenced by the stair-stepped
portion of the drawing.
FIG. 14
1/4"
1/2"
3/4"
1"
1 1/4"
Figure 15 provides information for using a custom panel in the toe kickplate
FIG. 15
area on overlay or framed models.
Panel thicker than 3/16
15/16 " TYP
4
7/8"
(A)
5/16"
2 " TYP
3/16
TYP
3/4"
Handle Considerations for Overlay Models
If the customer has specified a Jenn-Air
handle hardware. Handle hardware that the customer has specified to match the overall decorating scheme must
be provided separately at the job site.
Before installing the custom panel assembly, the custom
handle hardware must be installed. It is recommended that
handles with larger D-style pulls be used. If the screws that
are used have thick heads, the screws will need to be
countersunk into the panel before it is put into place.
Important: Because of continuing product improvements, Jenn-Air reserves the right to change specifications without notice. Dimensional specifications are provided for
planning purposes only. For complete details see installation instructions packed with product before selecting cabinetry, making cutouts or beginning installation.
20
Standard Handle Profile
(Framed Application)
1/4" Panel
Angled cut for thicker plates
"
6 1/4 "
(A) Three 3/16" holes may be used to attach panel to cabinet
5 "
5/8
"
13/16
(A)
Cut out for Dispenser
1 " R. 1/2"
13/16
Allow relief here for
DIA. 1/4" TYP
dispenser models with
panels thicker than 3/16"
1 1/8 " TYP
® Built-In Refrigerator Overlay model, the unit will be shipped without
FIG.12
Optional Extruded Optional Extended
Handle Kit
Handle Kit
(48) 46 7/8 "
(42) 40 7/8 "
IMPORTANT TIP: Jenn-Air advises not using single-
pull knobs on Built-In Refrigerator Overlay models.
2 7/16" Standard Handle
3 Optional Extended Handle
7/16"
FIG. 13
Handle Clearance For Raised Panel
Allow min. of 2
Non Dispenser
20"
5/16 "
(A)
3 3/4 "
3"