Connector Code; How To Read Connector Layout Diagram (Section 8A-3) - Suzuki 1999 SY413 Service Manual

8A-1-8 HOW TO USE THIS MANUAL
HOW TO READ CONNECTOR LAYOUT DIAGRAM
When necessary to know the location of an electrical part or an intermediate connector, it is easily possible to
retrieve it by this diagram.
First consult "SYSTEM CIRCUIT DIAGRAM" section or connector table at the right hand pages of this section
for the questioned connector code. Second refer to the diagrams of this section and look for the same code.
More information on use of the code is illustrated below.

Connector code

L 2 3
Connector No (serial No : 23)
Harness symbol (Refer to the table below)
Harness symbol and corresponding harness name
C : Engine harness No.1, No.2
E : Main harness, Oil pressure switch wire
G : Instrument panel harness
J : Front and rear door harness
L38
L37
(P01)
(N03)
L24
L39
(M01)
L22
L63
L21
(E109)
L25
L42
L23
12
L15
(N01)
L14
L16
L13
(K02)
L12
L11
L17
L09
K : Dome light harness
L : Floor harness, Fuel pump harness
O : Back door harness, RR defogger wire
Q : Air bag harness
This indicates the ground point No.
The same No. is used as the ground point.
(For the details, refer to "GROUND POINT" section)
This indicates the connector code.
The connector code in the parentheses ( ) has the same
meaning as the above intermediate connector and at the
same time, it indicates that there is a harness continuity
}
between pages or illustrations in "CONNECTOR LAYOUT
DIAGRAM" section. That is, it suggests that the harness is
continued to the other page or illustration and the continued
harness can be identified by the same connector code.