Turntable Motor
•
Location (See
Bottom View
•
120 VAC
Approximately 2.6 K :.
•
Troubleshooting
Note: To gain better access to components, remove
the wires that plug onto the large relays on the
Relay Board. (See
Relay Board.
the Smart Board CN103 wire harn ess (See
.) is routed through.
Board
Check voltage between either side of the Bottom
TCO and Relay Board connector CN6 pin 3.
•
If 120 VAC is present, problem is with
Turntable Motor, Primary Interlock Switch, or
wiring (See
Wiring Diagram
•
If 120 VAC is not present, the Turntable motor
relay on the Relay Board is not closing. See
Troubleshooting Section.
Relay Board
.)
) Cut the wire tie that
Smart
.) to motor.
– 59 –
Disassembly
To remove the Turntable Motor:
1. Remove the turntable, turntable support, and
the Bottom Cover.
2. Remove the 2 Phillips-head screws.
Note
•
When replacing the Turntable Motor, be sure the
RF gasket is positioned over the motor shaft and
between the motor and motor plate, as shown
below.
•
When replacing the turntable support, ensure
it is fully seated into the "D" shaped shaft of the
turntable motor and is À ush with the oven À oor.
RF Gasket
Disconnect
Motor Plate
RF Gasket
(Continued Next Page)