Demo Mode - GE Advantium PSA2200R Technical Service Manual

Demo Mode

The sales demo mode will allow dealers to demonstrate all oven functionality with one exception. (See #1
below.)
The sales demo mode can only be entered during the initial Clock: Set hour display that occurs when the unit
powers up after a long (greater than 60 seconds) power outage.
The sales demo mode will be initiated by holding the START/PAUSE and HELP pads down at the same time
for a full 3 seconds.
When sales demo mode is initiated, 2 short-beeps are sounded and all oven functions will operate with the
following exceptions;
1. No power shall ever be applied to the heaters, halogen lamps, magnetron high voltage transformer, or
Inrush control relays. The control relays for any of these loads shall not be switched during sales mode.
2. The DEMO icon will be lit whenever the unit is in sales mode regardless of settings or the feature being
selected.
The sales demo mode is cleared by holding the START/PAUSE and HELP pads down at same time for a full
3 seconds. The sales mode can only be cleared during the same initial Clock: Set hour display that occurs
when the unit powers up after a long (greater than 60 seconds) power outage. After 5 seconds elapse, all
functions of the oven will return to normal operation.
When power-up occurs, software will check the special sales demo identi¿ er code. If the code is set, then the
oven will stay in the sales demo mode. This will prevent the unit from powering back up to a normal mode if
power to the salesroom had gone off.
Clock: Set hour Clock: Set hour
0:00 0:00
Push Dial Push Dial to set to set
Demo Mode On Demo Mode On
Demo Mode Off Demo Mode Off
– 15 –
AM AM