16. Lift up the Air Tunnel Inlet, then remove wiring
from the 2 retainers.
17. Push wiring thru the entry hole, then remove the
Air Tunnel Inlet.
Air Tunnel Cover
The Air Tunnel Cover must be removed when
replacing the upper halogen heaters, heater TCOs,
and Stirrer Motor.
To remove the Air Tunnel Cover:
1. Remove the Outer Cover. (See
2. Remove the Ventilation Motor. (See
.)
Motor Removal
3. Compress the 2 pins holding the 2 wire retainers
to the air tunnel cover.
4. Remove the 8 Phillips-head screws that attach
the cover to the top of the oven.
Retainer
Retainer
.)
Outer Cover
Ventilation
– 26 –
5. Lift the cover and disconnect the light bulb wire
harness.
Air Tunnel Outlet
The Air Tunnel Outlet must be removed to access
the Oven TCO, halogen heaters, and halogen heater
TCOs.
To remove the Air Tunnel Outlet:
1. Remove the Humidity Sensor. (See
.)
Sensor Removal
2. Remove the 3 Phillips-head screws that attach
the Air Tunnel Outlet to the oven.
Pin
Pin
Harness
Humidity
(Continued next page)