Advertisement
1.
The electric water heater shall be installed on wall, vertical, outlet & inlet towards down. First
determine the installation position of the heater required and then make two holes in the wall with a
churn drill with reference to the mounting holes as shown in Fig. I. Drive anchor bolts into the holes
with a hammer. Secure the hook on the anchor bolts with nuts. Make sure it is fully fastened before
attaching the product to the hook.
2.
Connect the unit to main water pipe and inlet should stall a Non-Return Isolating Valve (tap) controls
water flow. Add detachable nuts at the inlet and outlet pipes for easy maintenance in future.
3.
The unit shall not be powered on unless you make sure that it is filled with water and all pipelines are
well installed without leakage and the power supply is correct.
4.
During the heating cycle, water will drip from the spout due to the thermal expansion, which is
normal. Tightening the inlet tap will not stop this and may damage the tap.
Method to full fill the water tank
(
that means the tank has been full filled with water, and can start heating.)
: Open the inlet tap till outlet has constant water flow without tubble,
Advertisement
