Instructions For Service Engineers Only - Triton TW10i Installation And Operating Instructions Manual

TW10i
INSTRUCTIONS FOR INSTALLERS AND
SERVICE ENGINEERS
Re-settable safety cut-out
This TW10i unit is fitted with a thermal cut-out to
prevent excessive heat and to protect the unit
under fault conditions.
In the event of operation the unit will require
manual re-setting as follows:
SWITCH OFF THE ELECTRIC SUPPLY AT THE
ISOLATING SWITCH.
Remove the front cover and press the red reset
button located on the thermal cut-out.
NOTE: Always isolate the electric supply to the
unit before removing the cover.
If the safety cut-out operates again after re-
setting, determine the nature of the fault to
prevent undue re-setting.
Contact Customer Service for advice if cut-out
continues to operate.
UKAS
QUALITY
MANAGEMENT
003
13