IKEA LEVERERA User Manual page 13

ENGLISH
What to do if...
Problem
The appliance cannot be
switched on or is not operat-
ing.
Acoustic signal sounds, ap-
pliance switches off.
The residual heat indicator is
not displaying anything.
There is no signal when you
touch the panel sensor fields.
symbol plus a number
appears on the heat setting
display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
More than 10 seconds
passed since you switched
on the hob.
The Child Safety Device or
the Lock is on .
Several sensor fields were
touched at the same time.
One or more sensor fields
have been covered for lon-
ger than 10 seconds.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Electronics fault.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply (refer to con-
nection diagram).
Switch the appliance on
again.
Deactivate the Child Safety
Device (See the section
"Child Safety Device" or
"Lock").
Only touch one sensor field.
Uncover sensor field.
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house's electric
system. If after switching on
again, is displayed
again, call the After Sales
Service.
13