Selecting The Sound Quality; Advanced Operations - Radio; Storing And Receiving Stations; Storing Automatically - Btm - Sony MEX-DV2200 Operating Instructions Manual

3
Press M/m to select "MLT," "2CH," or
"CD," then press (ENTER).
The setting is complete.
To hide the system setup display, press
(SYSTEM SETUP).
Note
For Super Audio CDs consisting of only a Super Audio
CD layer, that layer is played regardless of setting.
Tip
The setting in visual setup will switch the setting in
system setup automatically, and vice versa.

Selecting the sound quality

This unit allows you to change the sound quality
of Super Audio CD playback by switching the
sampling frequency.
The setting is configurable both from the visual
setup menu (page 41) and the system setup menu
(page 45).
The options for "SUPER AUDIO CD MODE"
(visual setup) and "SA-CD MOD" (system
setup) are indicated below.
HQ: Outputs at 176.4 kHz (high sound quality).
STD: Outputs at 44.1 kHz (standard CD sound
quality).
By the visual setup menu
The setting procedure is the same as for setting
the playback layer (page 35).
Press (VISUAL SETUP), then select "AUDIO
SETUP" c "SUPER AUDIO CD MODE" c
"HQ" or "STD."
By the system setup menu
The setting procedure is the same as for setting
the playback layer (page 35).
Press (SYSTEM SETUP), then select "SA-CD
MOD" c "HQ" or "STD."
Note
When set to "HQ," EQ7 (page 37), CSO (page 37),
Intelligent Time Alignment (page 38) and HPF/LPF
(page 49) settings are deactivated. To activate, set to
"STD."
Tip
The setting in visual setup will switch the setting in
system setup automatically, and vice versa.
36
Advanced Operations — Radio

Storing and receiving stations

SYSTEM
SETUP
M/m
Number
buttons
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press (SRC) repeatedly until "TUNER"
appears on the main unit.
To change the band, press (MODE)
repeatedly. You can select from FM1, FM2,
FM3, AM1 or AM2.
2
Press (SYSTEM SETUP).
The system setup item appears.
3
Press M/m to select "BTM," then press
(ENTER).
The unit stores stations in order of frequency
on the number buttons ((1) to (6)).
A beep sounds when the setting is stored.
With the main unit
Press (SOURCE) instead of (SRC), press (SETUP)
instead of (SYSTEM SETUP), rotate the control dial
instead of pressing M/m, then press the control dial
instead of (ENTER).

Storing manually

1
While receiving the station that you
want to store, press and hold a
number button ((1) to (6)) until
"MEM" appears on the main unit.
The number button indication appears on the
main unit.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.

Receiving stored stations

1
Select the band, then press a number
button ((1) to (6)).
ENTER
SRC
MODE