User Select 1 And 2 - nilan CTS 602 User Manual

User select 1 and 2

In the "User select" menu it is possible to overrule the operation mode in the main menu.
It is possible to e.g. increase the speed of the exhaustion for a limited period of time.
If the ventilation step and/or temperature is being adjusted in the main menu any active user selec-
tions are deleted.
If user selections are active due to external switches the function cannot be deleted.
" " indicates that the menu point flashes and can be set to another value.
ENTER
USER
SELECT
Required period in
which the selected
function is to remain
operative: stated in
hours and minutes.
Max 8 hours.
Required ventilation
step: 1-4.
OFF allows the system
to be shut down via an
external switch.
May be subject to change
Use of the CTS602 panel:
- press ESC to go one step back in the menu
- press qp
to move up or down in a menu or to adjust an
activated menu
- press ENTERto activate a menu
- press ENTERto confirm a menu
- press OFF to turn off the unit
- press ON to turn the unit on
Option for an extra relay output
R8. R8 is an accessory and
the option is only possible
via accessory pcb
The temperature is added
or subtracted to/from the
set point shown in the main
.
menu.
SELECT
ENTER
"EXTEND"
TIME TIME
ENTER
00:00
FLOW FLOW
ENTER
>4<
TEMP
TEMP
ENTER
23 °C
Required room temperature
(5-30°C).
T15 is the temperature sensor to
be used to control the system.
Figure 9: The "User select" menu
SELECT
"VENTILAT"
SELECT
"EXT OFFS"
SELECT
"EXHAUST"
SELECT
"00:00"
"INLET"
SELECT
">4<"
"EXTEND"
SELECT
"OFF"
"23" °C
Possibility to run at
a higher or lower
ENTER
rate. High priority.
ENTER
Choose the
afterrunning and
displacement of
the setpunkt, for
ENTER
externak heating.
See SELECT
EXTEND
ENTER
Time and speed must
be set in the same
way as described
under SELECT
EXTEND.
ENTER
Switches user option
off.
page 14 af 33