Subscribe to Our Youtube Channel
Related Manuals for nilan Comfort 1200
Summary of Contents for nilan Comfort 1200
- Page 1 Installation instruction CTS 602 by Nilan Comfort 1200 Comfort 5000 Version: 10.00, 13-04-2015 Software-version: 2.30...
-
Page 2: Table Of Contents
Table of contents Table of contents ..........................2 Introduction ............................. 3 Power supply ..........................4 Assembly of Comfort ........................5 Condensation drain / water seal ..................... 6 Heating surface, water ........................7 Heating surface, electrical (retrofitting) ................... 9 Activating the service menu ...................... 10 Heating surface ......................... -
Page 3: Introduction
(Directions for the CTS 602 control is described in another document delivered with the unit.) Comfort is delivered tested and ready for use. Installation and start-up must be carried out by an authorized electrician. Page 3 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 4: Power Supply
If a water heating element is installed in the system, the regulation vent must be connected electri- cally as described in the enclosed wiring diagrams. Page 4 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 5: Assembly Of Comfort
It is not necessary to re-insulate the system as it is delivered with a 20mm standard insulation. Comfort 1200/5000 4 x vibration absorbers Mounting the Comfort unit Page 5 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 6: Condensation Drain / Water Seal
The water seal should be tested as described below. (the unit must be connected to the ducting and the front door should be closed): Page 6 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 7: Heating Surface, Water
See electrical chart. Actuator and regulating valve: Danfoss AME 140/24V, - 3-vejsventil VZ3 DN15 Kv0,63, (Nilan delivery) Circulation pump, eg. Grundfos UPS 25-40 or equivalent (not Nilan supply) Dirt-catcher (not Nilan delivery) Shutoff valve (not Nilan delivery) - Page 8 6. Re-install the cover of the actuator. The actuator should be placed in an environment of 0°C to 55°C. Indicative performance data for the Comfort 1200 water heating element Pipe connection: Ø15 (by factory-mounted water heating element) Air supply tempera-...
-
Page 9: Heating Surface, Electrical (Retrofitting)
• Signal to overheating from the electrical heating element is connected to the CTS 602 print in the ventilation system. The Nilan supplied heating element is installed in accordance with the enclosed chart The heating element is now an option in the software via the control panel. See the instructions on the following pages. -
Page 10: Activating The Service Menu
ENTER SERVICE HOTWATER QUALITY EXCHANGE DEFROST TEMP. CONTROL INLET CONTROL ROOM CONTROL RESTART PRESET MANUAL MODBUS DATALOG INTV Headlines in the service menu Page 10 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 11: Heating Surface
01.00 and 06.00 o’clock. ENTER LEGIONEL ”OFF” TEMP. CONTROL Fuction is not active. INLET CONTROL ROOM CONTROL RESTART PRESET MANUAL MODBUS DATALOG INTV The “Central heating” menu Page 11 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 12: Air Quality
Can be set to: OFF, HUMIDITY or DEFROST HUM+CO2, when is mounted. TEMP. CONTROL INLET CONTROL ROOM CONTROL RESTART PRESET MANUAL MODBUS DATALOG INTV The “Air quality” menu Page 12 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 13: Air Exchange
Lüfterstufe ausgedrückt in % der >4< 100% maximale Lüfterleistung. MANUELL ABLUFT >1< MODBUS ABLUFT >2< DATALOG ABLUFT INTV >3< ABLUFT >4< 100% VERSöG BYPASS The "Air exchange" menu Page 13 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 14: Defrost
Adjustable temperature from 15 to 720 for discontinuing minutes. defrosting measured on PRESET T4, discharge censor MANUAL MODBUS DATALOG INTV The "Defrost" menu Page 14 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 15: Temp. Control
DATALOG INTV The "Temp. control" menu Page 15 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 16: Inlet Control
ENTER GAIN INLET 7.0%/° CONTROL INTEGRAL ROOM CONTROL 120 s N-ZONE RESTART 0.5°C TMP-RAMP PRESET 0.10°/s CAP-RAMP MANUAL 0.5%/s MODBUS DATALOG INTV The "Inlet control" menu Page 16 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 17: Room Control
RESPONSE RESTART N-ZONE ”SLOW” 2.0°C 2.0°C PRESET Rum control parametres: MANUAL Response Gain Integral Slow Normal MODBUS Fast User DATALOG INTV The "Room control" menu Page 17 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 18: Re-Start
FIRE: Auto restart when fire input is back INLET to normal CONTROL ROOM RESTART ”FIRE” CONTROL ENTER RESTART RESTART ”OFF” PRESET MANUAL MODBUS DATALOG INTV The "Restart" Page 18 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 19: Preset
PRESET ”STANDARD”. If a ”OFF” heating element is installed, it must be activated in the service MANUAL menu again. MODBUS DATALOG INTV The "Preset" menu Page 19 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 20: Manual
Test der Klappe RESTART MANUELL ”KLAPPE” Test der Abtaufunktion. PRESET MANUELL ”ABTAUEN” Manueller Test ENTER MANUELL MANUELL deaktiviert ”AUS” (normaler Betriebsmodus). MODBUS DATALOG INTV The "Manual" menu Page 20 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 21: Modbus
ENTER HEATING SERVICE SURFACE QUALITY EXCHANGE DEFROST TEMP. CONTROL INLET CONTROL ROOM CONTROL RESTART PRESET MANUEL Modbus Communication [1..247] MODBUS DATALOG INTV The "Modbus" menu Page 21 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 22: Datalog
INDBLÆS SERVICE VARME LUFT KVALITET LUFT SKIFTE AFRIMER TEMP. KONTROL INDBLÆS KONTROL KONTROL GENSTART NULSTIL MANUEL MODBUS Datalog inteval [1..120] minutter DATALOG INTV The "Datalog" Page 22 af 25 Nilan reserves the right to alter these instructions without prior notice... -
Page 23: System Dimensions
System dimensions System dimensions for Comfort 1200 Page 23 af 25 Nilan reserves the right to alter these instructions without prior notice... - Page 24 System dimensions for Comfort 5000 Page 24 af 25 Nilan reserves the right to alter these instructions without prior notice...
-
Page 25: Accessories/Spare Parts
3635 Vibration absorber 7722401 Humidity sensor 23997 -Sensor 7134B13 Heating cable for condensation outlet (frost protection) System Type Nilan item no. Comfort Heating cable 2172 Page 25 af 25 Nilan reserves the right to alter these instructions without prior notice...
Need help?
Do you have a question about the Comfort 1200 and is the answer not in the manual?
Questions and answers