Denon DN-MC6000 Service Manual page 30

FLOW CHARTNo.13 (405-MC6000-2782 : CONTROL UNIT)
JOG WHEEL is not operating.
(BEND function is not operating.)
Is D5V outputted at 2pin of CN104?
Is encoder waveform(0-3.3V) outputted to 1pin and
3pin of CN104, when JOG WHEEL is turned.
Check perifery circuit of IC100 from CN104, replace
it if devective.
When the periphery circuit is correct, replace
IC100.
O.K.
O.K.
N.G. Refer to FLOW CHART
NO.5<D5V is not outputted.>.
Check the contact point of CN104 and periphery
N.G.
circuit of it, and replace it if defective.
When the periphery circuit is correct, replace M301.
30