Condensation Water; Parts List - Philips Perfect Draft HD3610/50 Service Manual

TROUBLE SHOOTING
Problem
6 Beer leakage.

7 Condensation water

leakage.
8 No foam on the Beer.
9 To much foam
Cause
1. Leakage spout side.
2. Leakage on top of the Keg.
Through the cooling process condensation
water is formed and can drip under the
appliance.
Check the following conditions.
Check the following conditions.

PARTS LIST

Pos Service code
1 4222 459 45199
2 4222 459 45212
3 4222 459 45149
4 9965 000 44304
5 9965 000 26126
6 9965 000 32659
7 9965 000 26121
8 9965 000 26122
9 4222 459 45213
10 9965 000 26124
11 9965 000 26123
12* 4222 459 45215
13 4222 459 45216
14 9965 000 44309
15 9965 000 26117
16 9965 000 26115
17 9965 000 26116
18 9965 000 44310
19 9965 000 26111
20 4222 459 45214
21 9965 000 32874
22 9965 000 26110
23 9965 000 26109
24* 9965 000 26119
* Standardised part
Repair solution
1. Check beer tube on hairline cracks or check
closing mechanism tap unit.
2. Check beer tube, tap unit and Keg.
1. Check if doors were closed properly. (If not
closed extra condensation will be build)
2. Check if the drip tray was well placed.
1. Temperature of the Beer must be below 9 °C.
2. Glasses have to be clean.
3. Beer tube connector is not properly installed
or is damaged.
Check DFU for more tips.
1. Temperature of the Beer must be below 9 °C.
2. Beer tube connector is not properly installed
or is damaged.
3. Check if there is no air leakage in the system.
4. When the keg is almost empty it is possible
that only foam will come out.
Check DFU for more tips.
Description
Rear case assy
Right Door assy
Left Door assy
Connector/Lever assy
O-ring 11X2 Air inlet side
O-ring
Handle assy
Handle O-ring
Tap unit (without taphandle)
Spout O-ring
Spout
Plastic plate driptray top
Baseplate Driptray
NTC sensor assy
Pressure sensor PCB
Grommet. Pump position
Pump assy including pressure sensor
Power supply HV 220 - 240 V
Micro switch assy
Main PCB + 3 LED PCB
Drop ring
Grommet, FAN position
Fan assy
Peltier assy
HD3610/50
8-12