Section 4: Landing Gear Installation; Section5: Set Up Cg And Control Throw - Elite Models Yak55 Instruction Manual

Section 4: Landing Gear Installation

Step1. Glue the rectangle part into the slot on the
fuselage.
Step2. Glue two 210mm rods into the fuselage as
shown.
Step3. Use thin CA to quick glue the two round
parts into the landing gear wires. Then use foam
glue to glue two black pants onto the landing gear.
www.valuehobby.com/8mm-epp-yak55-V2.html
Step4. Install the battery, ESC and receiver as
shown.

Section5: Set up CG and control throw

The recommended CG is 218mm (8.6in) from the
nose of the fuselage.
Exponential for 3D flying
13