Machine Operation - Tennant 3220 607876 Operator And Parts Manual

OPERATION
3. Pull and turn quick-release hook to remove power
cord (Figure 6).
FIG. 6
4. Plug power cord into a grounded wall outlet
(Figure 7).
Grounded Outlet
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 7
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Activate ON/OFF switch.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
2. Lower handle to operating position by stepping on
handle release latch (Figure 8).
NOTE: Brush motor will not start until handle is lowered.
8
Grounding
Edge/hole
(220V/230V/240V)
Home Find... Go To..
FIG. 8
3. Begin vacuuming floor. Operate machine with a
back and forth motion or "W" pattern.
4. To operate in the horizontal position, lower handle
to the stop point and step on release latch again
(Figure 9).
Upright
Position
FIG. 9
5. To stop vacuuming, raise handle to the upright
position and turn off power switch.
Operating
Position
Horizontal
Position
Tennant 3220 (06- -03)