Table of Contents
Advertisement
Chapter
27
Connecting an HDMI device
This product
Notes
For details concerning the operations of
HDMI device, refer to Chapter 14.
When you connect the High Speed
HDMI® Cable, use the lock tie to fix it
securely.
For details, refer to Securing the High
Speed HDMI® Cable on page 60.
62
Engb
Connecting the rear display
This product
Yellow (V OUT)
Rear audio
output
Mini pin plug cable
(sold separately)
RCA cables
(sold separately)
To audio
inputs
To
video input
Rear display with
RCA input jacks
(sold separately)
■ When using a rear display con-
nected to rear video output
WARNING
NEVER install the rear display in a location
that enables the driver to watch the video
source while driving.
This product's rear video output is for con-
nection of a display to enable passengers in
the rear seats to watch the video source.
Installation
Precautions before
installation
CAUTION
Never install this product in places where, or
in a manner that:
— Could injure the driver or passengers if
the vehicle stops suddenly.
— May interfere with the driver's operation
of the vehicle, such as on the floor in
front of the driver's seat, or close to the
steering wheel or gearstick.
— To ensure proper installation, be sure
to use the supplied parts in the manner
specified. If any parts are not supplied
with this product, use compatible parts
in the manner specified after you have
the parts' compatibility checked by your
dealer. If parts other than supplied or
compatible ones are used, they may
damage internal parts of this product
or they may work loose and the product
may become detached.
— Do not install this product where it may
(i) obstruct the driver's vision, (ii) impair
the performance of any of the vehicle's
operating systems or safety features,
including airbags, hazard lamp buttons
or (iii) impair the driver's ability to safely
operate the vehicle.
— Never install this product in front of or
next to the place in the dashboard, door,
or pillar from which one of your vehi-
cle's airbags would deploy. Please refer
to your vehicle's owner's manual for
reference to the deployment area of the
frontal airbags.
Before installing
Consult with your nearest dealer if instal-
lation requires drilling holes or other
modifications of the vehicle.
Before making a final installation of this
product, temporarily connect the wiring
to confirm that the connections are cor-
rect and the system works properly.
Installing this product
■ Installation notes
Do not install this product in places
subject to high temperatures or humidity,
such as:
Places close to a heater, vent or air
conditioner.
Places exposed to direct sunlight, such
as on top of the dashboard.
Places that may be exposed to rain, such
as close to the door or on the vehicle's
floor.
Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors
in the vehicle's location display, and
might otherwise cause reduced display
performance.
30°
When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
Leave ample
5 cm
space
5 cm
■ Installation using the screw
holes on the side of this product
Fastening this product to the fac-
tory radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three
locations on each side.
Advertisement
Table of Contents
