Kickback; Cutting Branches; Repairs And Changing The Carbon Brushes; Maintenance, Cleaning And Storing - Westfalia 81 59 87 Instruction Manual

Kickback

 The electric branch cutter is equipped with a low-kickback chain. And from
an engineering point of view everything was done to keep kickback low as
possible. Nevertheless, kickback cannot be avoided when cutting with the
upper tip of the blade.
 Be prepared for some kickback when using this area of the blade or hitting
another branch with this area. Always hold the unit firmly in both hands.

Cutting Branches

 Thin branches can be cut off with one single cut. To
prevent the branch from slivering and buckling, the
branch should be cut off in several pieces.
 When cutting off lager branches, you should first cut into
the branch form below. First cut into the branch from
below outside the place where you intend to cut off the
branch. The cut should go from one third to halfway
through the branch.
 This prevents the branch from buckling when you cut
into the branch from the top outside the first cut.
 Last, cut off the stump with one clean cut. You might
want to seal the cut with a suitable compound.

Repairs and Changing the Carbon Brushes

 Repairs such as changing the carbon brushes should only be undertaken
by trained personal.
 Should a malfunction occur do not use the unit any further and do not
attempt to repair it yourself. In case of questions or problems turn to our
customer service.

Maintenance, Cleaning and Storing

 If you do not intent to use the electric branch cutter for some time, e.g. over
the winter, the bio-degradable chain saw oil must be drained from the oil
tank and the oil ducts, because it will gum and might damage the machine.
 Pour remaining oil out of the oil tank and store it in a dark, cool place. Pour
a spoonful of mineral oil into the oil tank. Spray penetrating lubricant on the
chain and let the saw run for a few moments to spread the mineral oil
through the oil pump and the oil ducts.
Operation
22