Table of Contents
Advertisement
13.0 Disposal
The symbols below, mean that in accordance with local
laws and regulations your product should be disposed of
separately from household waste.
When this product reaches the end of its life, take it to the
local collection point designated by local authorities. The
separate collection and recycling of your product at the
time of disposal will help conserve natural resources and
ensure that it is recycled in a manner that protects the
environment.
NOTE: Ensure you are the legal owner of the product prior
to arranging for the product disposal in accordance with
the above.
14.0 Torque Settings
WARNING!
•
Do not attempt to dismantle and/or reassemble the
scooter on an engineering level, or fit any replacement
parts or accessories if you are not qualified/authorised
to do so.
•
Always consult your approved Sunrise Medical
servicing agent.
The torque information supplied below will enable normal
routine maintenance tasks to be performed, (please also
see section 18).
GENERAL TORQUE SETTINGS
DESCRIPTION
M3 POZI PAN
M4 POZI PAN
M5 SKT HD CAP
M5 POZI PAN
M6 HEX HD
M6 BUTT HD
M6 SKT HD CAP
M8 HEX HD
M8 SKT HD CAP
M8 SKT BUTT HD
M10 HEX HD
M10 SKT BTT HD
SPECIFIC TORQUE SETTINGS
Front Wheel Axle Bolt
Rear Wheel Hub Studs
Seat Stem Height Bolts
36 Sterling S-Series
TORQUE VALUE
2-3 Nm
3-4 Nm
4-5 Nm
4-5 Nm
9-10 Nm
9-10 Nm
9-10 Nm
15-20 Nm
15-20 Nm
15-20 Nm
20-25 Nm
20-25 Nm
32-Nm
25Nm
20 Nm
15.0 Specification Sheets
Sunrise Medical
Thorns Road
Brierley Hill
West Midlands
DY5 2LD
England
Phone: 0845 605 66 88
Fax:
0845 605 66 89
www.SunriseMedical.co.uk
Operating temp:
Storage temp:
Moisture resistance: IPX4
No restrictions on humidity and air pressure.
Maximum occupant mass:
S400 = 136 kg, S425 = 150 kg, S700 = 160 kg
The Sterling S-series scooters conform to the following
standards:
a) requirements and test methods for static, impact and
fatigue strengths (ISO 7176-8)
b) power and control systems for electric wheelchairs
requirements and test methods (ISO 7176-14)
c) climatic test in accordance with ISO 7176-9
d) requirements for resistance to ignition in accordance
with ISO 7176-16
e) the product is specified as a Class B, (S400-S425),
Class C, (S700), power product
f) all materials used on this product conform to EN1021
parts 1 and 2
NOTE:
•
See charts on following pages.
•
Measurments of upholstered parts are approximate.
All other measurments may be subject to change.
CAUTION!
This scooter has not been tested to ISO 7176-19 for use
as a seat when travelling in a vehicle.
(EN 12184 & ISO 7176-15)
-25°C to 50°C
-40°C to 65°C
Hide quick links:
Advertisement
Table of Contents
