Packet Communications; Packet Communication Connections - Alinco DJ-G7 Instruction Manual

12.Cloning I PC Connection Functions
( 12-4 Packet Communications
Packet communication enables data transmission and reception through a TNC
(modem) unit.
12·4·1 Packet Communication Connections
When using this transceiver for packet communications, refer to the illustration
below and connect it to a TNC following these steps:
Connect an optional EDS 14 microphone/speaker plug conversion cable to the
earphone/microphone terminal at the top of this transceiver, and connect a TNC
(Terminal Node Controller) to the speaker terminal (using a 3.50 plug) and to the
microphone terminal (using a 2.50 plug).
oAdjusting the input level:
This transceiver doesn't have a function to adjust the
microphone input level. Adjust that level from the TNC, if necessary.
oAdjusting the output level:
Adjust the output level from the earphone/microphone terminals using the
audio output dial on the transceiver.
EDS-14 terminal
TNC
---------,
3.50
plug
:3 I
SP
~
"d
Speaker terminal
T
1(3,50)
GND
' I N
- - I I
1 ,
10F
__ -I
I
2.50 plug
~
MIC
C
~
Microphone
l________
J
terminal (2.50)
PTI
(Low)
GND
EDS-14 plug
---------,
I 1
:'o--:-v
"
I '
1 I
L
.l
106
o
C AIITION
·Voltage will be supplied through a 100 ohm resistor from the internal
3.3V line.
oPlease follow the TNC Instruction manual for Information on
connecting the TNC to a PC.
·If this transceiver, the TNC and the PC are In close proximity, noise
may be
pres~nt.
·Durlng packet communications, turn the Battery Save function off.
000
not exceed 1,200 bps during packet operations.
IF