Using The Presentation Timer - Mitsubishi Electric XD50U User Manual

General Operation

Using the Presentation Timer

The presentation is given while checking the timer displayed
on the screen.
The gauge display allows the remaining time to be known at
a glance.
(1) Press the TIMER button to show the settings display.
The display will close when an operation has not been made
for about 10 seconds.
Presentation Timer
[Timer settings display]
Press the CANCEL button to close the display immediately.
(2) Press the "+" or the "–" button to set the time.
The setting contents are "Off" and from 10 to 60 minutes (in
10-minute intervals)
Settings can also be made with the SELECT
Presentation Timer
(3) Press the ENTER button and start the timer.
• The display of the timer setting will close, the display of the
timer will appear and simultaneously the timer will start.
[Timer Display]
The blue gauge indicates the remaining time. When the
gauge disappears,the time is up.
The gauge continues to be displayed when the timer is
stopped.
• Press the ENTER button to restart the timer. The timer will
start with the same time setting.
• Press the CANCEL button to close the timer display. The
timer setting will return to "Off".
Moving the Position of the Timer Display
The SELECT buttons on the remote control permit move-
ment within the movable range of the timer display.
Note:
* The timer display will be closed while the menu or the quick menu is displayed, and while a message is displayed; however, the timer will
still be operating at such times. Also, the timer will not be displayed unless a signal is being input.
* While the presentation timer is being displayed, screen movement will not be possible in the zoom mode.
Off
buttons.
10 min.
Gauge (Blue)
When the remaining time is
"0" (Gray)
E-29
(1)
ZOOM
(2)
Movable Range of the Timer Display
(3)
ENTER
VOL