Intended Use; Technical Data; Declaration Of Conformity - Bosch GSR 14,4 V-LI Original Instructions Manual

10 | English
Symbol Meaning
Read all safety warnings and all instruc-
tions
Before any work on the machine itself,
remove the battery
Wear ear protection.
Movement direction
Reaction direction
Drilling and screwdriving
Impact drilling
Low speed
High speed
Switching On
Switching Off
Right/left rotation
Battery Capacity
U Rated voltage
n Impact rate
S
n 1 No-load speed (1. gear)
0
n 2 No-load speed (2. gear)
0
M Maximum torque according to ISO 5393
Brickwork
Metal
Wood
Ø Drilling diameter, max.
Ø Max. screw dia.
Chuck clamping range
Weight according to EPTA-Procedure
01/2003
L Sound power level
wA
2 609 133 256 | (14.11.11)
Symbol Meaning
L Sound pressure level
pA
K Uncertainty
a Vibration total value
h
Delivery Scope
Cordless screwdriver/Combination cordless drill.
Battery, application tools and other accessories shown or de-
scribed are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.

Intended Use

The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal, ceramics and plastic.
GSB machines are additionally intended for impact drilling in
bricks, brickwork and masonry.

Technical Data

The technical data of the machine are listed in the table on
page 137–138.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
02.11.2011
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 137–138.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given
in EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
Dr. Eckerhard Strötgen
Engineering Director
PT/ESI
Bosch Power Tools