ORD RoVa3D User Manual page 70

User Manual
The close up on the left in the picture above compares a 400 micron layer height to a 200 micron layer height.
If you look closely, you can see that there are 7 layers in the tentacle on the left and 14 layers in the tentacle on
the right.
The close up on the right compares the 200 micron layer height to the 100 micron layer height. Because the
layer height is halved in the 100 micron print, the layers tentacle are doubled again to 28.
When handling these prints, you can definitely notice a ridged feel on the 400 micron layer print. The 100
micron layer print feels smooth. It's only if you drag your fingernail across the print that you can tell that the
object is made up of individual layers.
Here's another print comparison:
orddistribution.com Copyright 2015 ORD Solutions (Dist.) Inc. Page 70