Leveling Nozzles - ORD RoVa3D User Manual

User Manual
10. Reach under the printer and adjust he respective 'bed adjustment screw' to move the print bed until it
skims the surface of the socket
11. Repeat steps 6 to 11 to confirm print bed level
2.3.17.

Leveling Nozzles

The nozzles are held into position with two nuts located on the threaded barrels at the top of the printer. These
nuts are all 10mm in size. The nuts have a 1mm pitch which makes adjustment very easy, for example, to adjust
the height by 0.1mm turn the nut 1/10
Always level the nozzles as close to the center of the print bed as possible. You will need a deep ¾" socket (or
similar size). This will be used as a gauge block to allow easier measurement of the gap between nozzles and
the bed.
Place a mark on the top of the socket, as shown in the picture below, to ensure that you are always measuring
to the same spot on the socket.
orddistribution.com
of a turn.
th
Copyright 2015 ORD Solutions (Dist.) Inc. Page 37