ORD RoVa3D User Manual page 22

User Manual
Pronterface Overview – Right Side
Testing Communication
1. Open Pronterface using the shortcut. (Printrun is what is shown on Macs)
2. Change the baud rate to 250000
3. Select the Port that the RoVa3D is connected to.
a. Click the Port button to scan for open ports. The RoVa3D will typically be the highest port
number shown.
b. If you are unable to determine which port the RoVa3D is connected to, run Device Manager,
expand Ports, and look for the COM port assigned to the last entry of 'USB Serial Port'
4. Click the Connect button and wait for it to connect to the RoVa3D. After a successful connection to the
RoVa3D, you will see the firmware settings displayed in the right side window of Pronterface.
orddistribution.com Copyright 2015 ORD Solutions (Dist.) Inc. Page 22