Shear Bolt Or Slip Clutch Driveline Installation - RHINO RX5 Operator's Manual

SHEAR BOLT or SLIP CLUTCH DRIVELINE INSTALLATION

Attach rear driveline of U-Joint to input shaft on gearbox, install snap ring in groove on input shaft.
NOTE: Check that Snap Ring is properly seated in groove.
This snap ring retains driveline when shear bolt shears. Install Grad 2 (Only) shear bolt 1/2" x 2-3/4". Use of a
stronger shear bolt other than Grade 2, will result in driveline failure and will void warranty. Figure AsmP-R-
0043.
Front Deflectors and Rear Metal Band (Standard Equipment)
Front rubber-fabric Deflectors are Standard Equipment. Guard must be installed (and
maintained in good repair) except for agricultural purposes only in areas where persons,
vehicles, livestock, or other property will not be endangered by thrown objects and where
such safety equipment would prevent the mower's reasonable performance of its assigned
agricultural task.
Deflectors: Front Deflectors (Standard Equipment) are recommended for the average user and will provide
protection from thrown objects with proper operation under normal conditions. Deflectors must be maintained
in good repair or replaced after no more than two inches of wear off lower edge.
RX5-RX6 02/10
© 2010 Alamo Group Inc.
ASSEMBLY
Assy02-Shielding
Assembly Section 3-5