ASSEMBLY
SHEAR BOLT or SLIP CLUTCH DRIVELINE INSTALLATION
Attach rear driveline of U-Joint to input Shaft on gearbox, install Snap Ring in groove on Input Shaft.
NOTE: Check that Snap Ring is properly seated in groove.
This Snap Ring retains Driveline when shear bolt shears. Install Grade 2 (only) shear bolt 1/2" by 3". Use of a
stronger shear bolt than Grade 2, will result in driveline failure and will void warranty. Figure Asm-R-0043.
Attach slip clutch driveline to input shaft on gearbox with Grade 8 Bolt Figure Asm-R-0073 & AsmP-R-0487.
Refer to proper Torque Chart in Maintenance Section of this manual.
160 07/12
Assembly Section 3-6
© 2012 Alamo Group Inc.