Hyundai DF 928 Instruction Manual page 22

5. Make sure that fryer is off and insert plug into power socket. To turn fryer on, slide
ADJUSTABLE THERMOSTAT to the desired temperature. The READY LIGHT will come on
when the set temperature is reached.
6. Raise FRYING BASKET, then open LID.
7. Place food to be cooked in FRYING BASKET, close LID and lower handle.
CAUTION: Remove any excess ice crystal on frozen foods before placing in basket.
8. Cook according to the Frying Chart or your favorite recipe.
9. Raise FRYING BASKET and open LID. To remove excess grease and retain crispness, let
food drain in FRYING BASKET, then lift FRYING BASKET by HANDLE and pour contents
onto plate covered with paper towels before serving.
Cleaning
WARNING: ALWAYS TURN CONTROL TO „OFF" THEN DISCONNECT PLUG FROM WALL
OUTLET.
1. Switch unit off
2. Unplug from outlet and allow unit to cool completely.
3. Clean the outside of the fryer and LID with a damp cloth.
Caution: Do not use abrasive pads or alcohol.
4. Remove FRYING BASKET. Wash the FRYING BASKET
in hot soapy water. Rinse and towel dry carefully.
5. Store your fryer with the LID closed to preserve the oil.
6. When changing the oil, take the opportunity to clean the
inside of the fryer.Remove LID, pour out oil and discard
properly.
7. The removable oil reservoir/bowl is immersible and
dishwasher safe. To clean, first remove from unit by
lifting bowl straight up out of the plastic exterior (Fig. C).
Wipe the inside with paper towels to absorb excess.
Wash the inside of the bowl with hor soapy water
and rinse or place in dishwasher. Dry thoroughly.
8. To replace oil reservoir//bowl be sure the chrome
guide post (between the 2 electric prongs) is aligned
properly with the center hole of receptacle at the rear
of the unit (Fig. D). The chrome guide post should guide
the electric prongs into the correct
on reservoir/bowl to ensure it is positioned properly.
Lid should close tighly.
Note: If the unit does not heat up after plugging in,
try re-positioning the reservoir/bowl, ensure the rim
of bowl sits flat inside the exterior housing.
WARNING: Do not remove oil reservoir/bowl until
the unit has cooled and is unplugged.
CAUUTION: NEver immerse the plastic exterior
of the fryer in water, or wash in running water.
position. Firmly press
EN - 22