Table of Contents
Advertisement
5840_CIB_2ATT
2002.11.7
figure a
figure b
figure c
figure d
figure e
5:47 PM
Page 5
Wall Installation
1
Connect the power cord and
telephone line cord to the underside
of the corded base, as shown
(figure a).
2
Position the mounting bracket as
shown (figure b).
3
Feed the telephone line cord through
the hole in the center of the mounting
bracket (figure b), align the bracket
with the base, and slide it into the
hole on the base as shown (figure c).
4
Lock the mounting bracket in place
(figure d).
5
Plug the telephone line cord into a
modular wall jack, and mount the
base on the wall (figure e).
a) Align holes on base with mounting
studs on wall jack.
b) Place power cord as shown.
c) Pull base down on mounting studs
until it locks into place.
6
Plug the power cord into an
electrical outlet not controlled by a
wall switch (figure e).
7
Follow Steps 3–5 in "Table/Desktop
Installation."
Use only the power cord supplied
with this product. If you need a
replacement, call 1 800 222–3111.
5
Advertisement
Table of Contents
