Door Installation - Inca Metal Cutting Tasman DV Linear ESSENCE Installation And Operating Instructions Manual

3.3.5 Door Installation

Fit the top of the door onto the top door brackets, make sure the door is centered on the appliance.
Push the bottom of the door into the appliance and pull the 2 door lock bars down, forward and up to
secure the door in place. Replace lower access strip in front of door.
Monter en haut de la porte sur les supports porte du haut, assurez-vous que la porte est centrée sur
l'appareil. Poussez le bas de la porte dans l'appareil et tirez le verrou de la porte 2 barres vers le bas,
vers l'avant et à sécuriser la porte en place. Remplacer la bande inférieure d'accès en face de la
porte.
Removal is in reverse order. / L'enlèvement est dans l'ordre inverse.
If the glass has been damaged or broken it is highly recommended that you contact a qualified
service person. Remove the broken pieces (be sure to wear gloves) and remove door. See the
replacement parts list, at the end of the manual, you will require one 5 mm ceramic glass panel with
gasket installed. Lay in a blob of high temperature silicone in each of the four corners of the door
Page 33 of 54