Toyota 2010 Prius Owner's Manual page 415

■
Programming a Rolling Code system (for U.S.A. owners)
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
the steps listed below.
STEP 1
Locate the learn button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the learn button.
STEP 2
Press the learn button.
STEP 3
Press and hold the vehicle's programmed HomeLink
for 2 seconds and release it. Repeat this step one again. The
garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
STEP 4
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
www.mycar.pk
®
transceiver and operate the garage door.
Umar: 03214530584
3-6. Other interior features
®
" before proceeding with
®
buttons.
www.prius.pk
®
button
3
391