Before Starting Engine; Add Oil; Add Gasoline; To Start Engine - Husqvarna HU725AWDH Operator's Manual

Hide thumbs Also See for HU725AWDH:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION
BAG
HANDLE
GRASS
CATCHER
FRAME
HANDLE
FIG. 10
BEFORE STARTING
ENGINE
ADD OiL (See Fig. 1 1)
Your lawnmower is shipped without oil in the engine. For
type and grade of oil to use, see "ENGINE" in the Mainte-
nance section of this manual.
CAUTION: DO NOT overfill engine with
oil, or it will smoke heavily from the
muffler on startup.
1.
Be sure lawnmower is level.
2.
Remove oil dipstick from oil fill spout.
3.
You receive a container of oil with the unit.
Slowly
pour the entire container down the oil fill spout into
the engine.
NOTE: Initial oil fill requires only 15 oz. due to residual oil
in engine from the manufacturers
100% quality testing.
When changing oil you may need 16 oz.
4.
Insert and tighten dipstick.
IMPORTANT:
Check oil level before each use. Add oil if needed.
Fill to full line on dipstick.
Change the oil after every 25 hours of operation or
each season. You may need to change the oil more
often under dusty, dirty conditions.
See "TO CHANGE
ENGINE OI1" in the Maintenance section ofthis manual.
ADD GASOLINE
(See Fig. 1 1)
Fill fuel tank to bottom of tank filler neck. Do not over-
fill. Use fresh, clean, regular unleaded gasoline with a
minimum of 87 octane.
Do not mix oil with gasoline.
Purchase fuel in quantities that can be used within 30
days to assure fuel freshness.
Acidic gas can damage
the fuel sys-
tem of an engine while in storage.
To
avoid engine problems, the fuel system
should be emptied before storage of
30 days or longer.
Empty the gas tank,
start the engine and let it run until the
fuel lines and carburetor are empty. Use
fresh fuel next season.
See Storage
Instructions
for additional information.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
ENGINE OIL
GASOLINE
FILLER
CAP
FIG. 11
TO STOP ENGINE
To stop engine, release operator presence control bar.
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small
amount of smoke may be present during the initial use of
the product and should be considered normal.
NOTE: Your engine is equipped with an automatic choke
system. No priming or choking is required before starting.
To start engine, hold operator presence control bar
down to the handle and pull starter handle quickly.
Do not allow starter rope to snap back.
&
CAUTION: Alcohol blended fuels (called
gasohol or using ethanol or methanol)
can attract
moisture which
leads
to
separation and formation
of acids dur=
ing storage.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents