To Assemble Grass Catcher; Install Starter Rope; To Install Attachments - Husqvarna HU725AWDH Operator's Manual

ASSEMBLY
\
/
/
J
HANDLE
BRACKET
FiG. 2
TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: Ifvinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
>_--7-'_ \_/ /xx/ '-'_ \_/ /x_/ FRAME
// _ _/ HANDLE
/
VINYL FRAME
OPENING
FIG. 3
INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
CONTROL BAR
UPPER
ROPE GUIDE T-KNOB
ENGINE
ROPE
FIG. 4
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see "TO CONVERT MOWER" in the Operation section of
this manual.
5