Mitsubishi CP900E Operation Manual page 56

ERROR MESSAGES & COUNTERMEASURES
Symptom
The stored image in the memory cannot be
enlarged to fill the maxim print area.
The colour or picture quality is different
between the memorized image and the
printed image.
When inputting monochrome image signal
(without burst signal), sync. becomes unstable.
The colour or picture quality is different between Is the image on the monitor screen adjusted?
the image on the monitor screen and the
printed image. (When the colour and picture
quality are same between the image stored in
the memory and the printed image.)
The set comments do not appear on the
print paper.
Wired remote control unit cannot be operated.
The printing unit cannot be opened.
56
Check and Remedy
Is the S size ink sheet installed when selecting "S" in MODE : AUTO/S? Or
is the L size ink sheet installed when selecting "AUTO" in MODE : AUTO/S?
Check the current setting. Refer to pages 23-24.
Is the paper size set to "N" in the size setting in LAYOUT menu?
Set the size to "M" or "W". Refer to pages 34, 41.
Is the print area set correctly in LAYOUT menu?
Check the setting of the print area. Refer to pages 40-42.
Is the colour of the image stored in the memory adjusted?
Adjust the colour of the image stored in the memory with Colour
adjustment display (COLOR ADJ). Refer to page 40.
Is INPUT in ANALOG COLOR ADJ set to "COLOR"?
Set INPUT to "B&W". Refer to page 48.
Adjust the image on the monitor screen with "MONI R-SUB" and "MONI
B-SUB" in the OUTPUT menu.
Refer to page 50.
Is the COMMENT set to "OFF"?
Set COMMENT to "ON". Refer to page 43.
Is the comment inputted?
Input the comment on the menu. Refer to pages 43-44.
Is the plug of the remote control unit disconnected from its terminal on the
unit?
Connect the plug of the remote control unit to the REMOTE terminal on
the unit.
The supplied remote control unit can not be used by connecting to the
external remote terminal on the rear panel of this unit.
Is the wired remote control unit for this unit (accessory) used?
Use the remote control unit for this unit.
Is PAPER HOLD set to "ON", and is printed paper kept at the print outlet?
Remove the printed paper from the print outlet.
Is KEY LOCK set to "ON"?
Set KEY LOCK to "OFF".
Is the paper cut after prinitng with THERMAL : ON and AUTO CUT : OFF?
Press MEMORY button while pressing MONITOR button to cut the printed
paper.