Troubleshooting - Sony SRX-R515P Operating Instructions Manual

Caution
If STATUS 1 indicator does not turn solid green even after
a few minutes when connected to the server, contact
qualified Sony service personnel.
Server (front)
POWER
Lit red
Blinking green (rapid)
Lit green
Caution
When the MAIN indicator is solid red and the IMB
indicator is solid green, do not set the power switch on the
rear of the projectors to OFF. After shutting down from the
server, set the power switch on the rear of the projectors to
off.
HDD1 indicator: Shows that the hard disk drive for the
system is being accessed.
HDD2 indicator: This indicates the RAID access
containing the DCP.
Device status
Standby mode
Starting up, shutting down
Startup complete

Troubleshooting

Check this section before consulting qualified Sony
service personnel. If the unit still does not function
properly, consult qualified Sony service personnel.
To check installation/connections
In the "Status" window, check to make sure that the lens
mount, lamp mount, and server connection are properly
married.
1
In the [Status] tab, tap [Auditorium] and check that
the lens is correctly mounted.
2
Tap [Status] and confirm that the lamp for each item
is lit solid green.
Lamp mounting
Lamps
Lamp colors show the health status of each part of the
unit.
Green: normal
Yellow: warning (title will continue to be shown)
Red: error (title will stop)
44
A message about the lens
mounting can be seen here.
Server connection
Marriage indicator