Safety - GFS 1000 Safety & Operation Manual

IMPORTANT INFORMATION TO KNOW. PLEASE
READ BEFORE USE.
Read and understand tool labels
and all of operating instructions,
safety precautions and warnings in
this manual before operating or
maintaining this nailer.
Failure to follow warnings could result in DEATH
or SERIOUS INJURY.
Most accidents that result from the operation and
maintenance of Nailers are caused by the failure
to observe basic safety rules or precautions. An
accident can often be avoided by recognizing
a potentially hazardous situation before it
occurs, and by observing appropriate safety
procedures.
Basic safety precautions are outlined in the
"SAFETY" section of this Manual
Hazards that must be avoided to prevent bodily
injury or machine damage are identified by
DANGERS and WARNINGS on the Nailer and in
this Manual
Never use this Nailer for applications other than
those specified in this Manual.
DEFINITIONS OF SIGNAL WORDS
DANGER indicates an imminent hazardous situation
which, if not avoided, will result in death
or serious injury.
WARNING indicates a potentially hazardous
situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a potentially hazardous
situation which, if not avoided, may
result in minor or moderate injury, or
may cause machine damage.
NOTE emphasizes essential information.
EXPLANATION OF THE FUNCTION OF THE GFS
NAILER
This tool has a FULL SEQUENTIAL ACTUATION
MECHANISM （on the nailer body mark del operator
First, press the push lever ( push lever be called
apart of the full sequential actuation mechanism)
against the workpiece; press down of the nailer,
and then pull the trigger to drive the nail. Follow
the same sequence to continue driving nails after
the push lever and trigger are return back in place.
1

SAFETY

IMPORTANT SAFETY INSTRUCTIONS FOR
USING NAILERS
READ ALL INSTRUCTIONS
DANGER
1. OPERATORS AND OTHERS IN WORK AREA
MUST WEAR SAFETY GLASSES WITH SIDE
SHIELDS.
Safety glasses must conform to the requirements
of American National Standards Institute,
ANSI Z87.1 and provide protection against flying
particles both from the front and side.
T he e m p lo ye r m u st e nf or ce the use of
safety glasses by the Nailer operator and
others in work area.
2. NEVER USE IN PRESENCE OF FLAMMABLE
LIQUIDS OR GASES.
thinner or gasoline.
This Nailer produces hot exhaust gases that
may ignite flammable materials and produces
sparks during operation.
3. DO NOT TOUCH AROUND THE EXHAUST
OUTLET.
prolonged or rapid use.
Do not touch with bare hands.
）.
4. EXPLOSION AND FIRE HAZARD.
This Nailer is powered by internal
combustion device.
This Nailer shall only be used with
dispensers for combustible gas
which are listed in this manual.
When operating the Nailer, always
wear safety glasses with side
shields, and make sure others in
work area wear safety glasses.
This Nailer must not be used in a
com bustible envir onment or in
presence of flammable liquids or
gases, e.g. lacquer, paint, benzine,
This Nailer produces hot exhaust
gases that may flammable materials.
T he pus h l ev er and nose will
become hot and get heated up after
The fuel cell is an aerosol dispensers
with flammable contents.
P r essur ed container and the
propellant will remain in the fuel cell.
Faillure to follow instructions may
result in explosion or fire.