Maintenance And Inspection; Using The Hook - GFS 1000 Safety & Operation Manual

Note When the pins are fire into smooth surface,
suggest use the pushing arm jacket, such as
the sheet steel;
When nails are fire into the wood, suggest
do not use the pushing arm jacket.
Fitting and remove the push arm jacket
When fitting the pushing arm jacket, it is will
cover on to the pushing arm after been stress
extrusion.
When remove the pushing arm jacket, can use
the tool remove it form the pushing arm.
Pushing Arm
Push Arm Jacket

USING THE HOOK

CAUTION
Using the hook, can hang on the nailer to the work
belt or scaffolding on work.
This nailer hook can left and right side by side mounting ,
as (a) and (b).
a
If need, can according to the following steps exchange ：
(1) Use accessory wrench (M5) loosen and pull out
two screws ;
(2) Pull out the hook, reversal insert ;
(3) Insert the screws and tightening.
The screws must make sure be tightening to avoid
the hook fall off cause to the nailer damage or hurt
someone.
If the tool falls, there is a risk that malfunctions or
parts damage can occur.
It is recommended that you also use fall- preventing
wires, etc.
b
MAINTENANCE
NOTE:
■ The information contained in this Manual is designed
to assist you in the safe maintenance of the Nailer.
■ Some illustrations in this Manual may show details
or attachments that differ from those on your own
Nailer.

MAINTENANCE AND INSPECTION

Read section titled "SAFETY".
DANGER
■ Never use and test in presence
of flammable liquids or gases.
■ Keep away from ignition source.
■ No smoking.
WARNING
Remove fuel cell, battery and all nails from Nailer
when:
Daily cleaning;
Maintenance and Inspection;
Clearing a jam.
1. Daily cleaning
Must regularly to clean nailer, remove the internal
accumulation of smeary, carbon and dust, and to
ensure the normal operate, extend nailer working
life. Please use
(504.6.04.001.01).
Follow the attachment Gas Concrete Nailer
Cleaning Guide-a steps and methods to clean
the nailer.
nailer cleaning intervals depends on the
nailer operating environment and the firing quantity
per week of nails. If using at the dirty environmental
and firing large quantity per week, nailer cleaning
intervals will be shorter.
Below is the cleaning time intervals form for you
reference. If you according to the cleaning time
intervals form to clean the nailer find the nailer is
extremely dirty, the cleaning time intervals should
be shorten, conversely, if find ther nailer is very
clean, extend cleaning time intervals.
designated cleaner
16