Loading Nails - GFS 1000 Safety & Operation Manual

(4) Remove the finger from the trigger and press the
push lever against the workpiece with pulling
backward the feeder knob, motor fan start.
Depress push
lever against the
work piece
■ THE NAILER MUST NOT OPERATE.
(5) Separate the push lever from the workpiece.
Next, point the push lever downward and leave
workpiece, pull the trigger and then wait in that
position for 5 seconds or longer.
If burst, this means the push lever have not
replacing, the cylinder have not open, nailer is
anomaly.
■ THE NAILER MUST NOT OPERATE.
(6) Depress the push lever against the workpiece,
downward nailer, pull the trigger.
■ THE NAILER MUST OPERATE.
(7) If no abnormal operation is observed, you may
load nails in the Nailer.
Drive nails into the workpiece that is the same
type to be used in the actual application.
■ THE NAILER MUST OPERATE PROPERLY.

LOADING NAILS

WARNING
■ When loading nails into Nailer,
1) do not depress trigger;
2) do not depress push lever;
3) keep the Nailer pointed downward.
13
Do not pull
the trigger
Nail Feeder
Feeder Knob
Pull the trigger
Nail Feeding Step
(1) Insert nails into the back of the magazine
(see chart a)
chart a
(2) Hand slide the nails forward in the magazine
(see chart b).
Chart b
(3) Pull the nail feeder a little pass the back of nails
(see chart c), loosen feeder knob, nail feeder
automate against to the nails( see chart d).
Chart c
Chart d
NOTE:
■ Quietly push the feeder knob to bring the nail
feeder to the end of the magazine, loosen the
feeder knob let the nail feeder slowly forward
against the nail.
■ Use nail strip of more than 4 nails.
The Nailer is now ready to operate.
Plastic strip nails
Magazine
Nail Feeder